加强型玻璃陶瓷厚度对树脂水门汀固化效率的影响

doi:10.19439/j.sjos.2017.05.006

上海口腔医学 ›› 2017, Vol. 26 ›› Issue (5): 492-497.doi: 10.19439/j.sjos.2017.05.006

加强型玻璃陶瓷厚度对树脂水门汀固化效率的影响

朱琳琳, 仇丽鸿, 刘丽杨, 李晓琳

中国医科大学附属口腔医院,辽宁沈阳 110002

收稿日期:2017-01-02 修回日期:2017-05-26 出版日期:2017-10-25 发布日期:2017-11-23
通讯作者: 仇丽鸿,E-mail：drqlh@yahoo.com
作者简介:朱琳琳（1981-）,女,博士,主治医师,E-mail:linlin.zhu@163.com

Effect of the thickness of reinforced glass ceramics on the degree of conversion of dual-cure resin cements

ZHU Lin-lin, QIU Li-hong, LIU Li-yang, LI Xiao-lin

Hospital of Stomatology, China Medical University. Shenyang 110002, Liaoning Province, China

Received:2017-01-02 Revised:2017-05-26 Online:2017-10-25 Published:2017-11-23

摘要/Abstract

摘要： 目的评估不同厚度加强型玻璃陶瓷对3种双固化树脂水门汀Multilink N（Ivoclar Vivadent）、RelyX Ultimate（3M）以及NX3-Nexus（Kerr）聚合转化率（degree of conversion, DC）的影响。方法使用硬组织切片机将upcera锂瓷、e.max瓷制作成厚度分别为（2.00±0.05）mm、（3.00±0.05）mm和（4.00±0.05）mm的3组正方形瓷片,应用紫外可见近红外分光光度计测量波长400~515 nm可见光范围内的透射率。利用傅里叶红外光谱仪,检测“C=C”吸收峰和“C-C”吸收峰的吸光度值,计算树脂水门汀的DC。采用SPSS 21.0软件包对数据进行统计学分析。结果2种瓷片在所检测可见光范围内随着厚度的增加,可见光透光率明显降低。在一定波长范围内,2 mm厚度的upcera锂瓷透光率高于e.max瓷,3 mm、4 mm 2种瓷片透光率差异无显著性。2 mm厚度的upcera锂瓷和2 mm厚度的e.max瓷作为固化中介物时,Mutilink N和RelyX Ultimate 的固化效率低于NX3-Nexus组。结论瓷片厚度为2 mm时,upcera锂瓷的透光率高于e.max瓷。upcera锂瓷对Mutilink N和RelyX Ultimate固化效率的影响大于e.max瓷。

关键词: 加强型玻璃陶瓷, 树脂水门汀, 固化效率

Abstract: PURPOSE: To determine the effect of the thickness of reinforced glass ceramics on the degree of conversion (DC) of three dual-cure resin cements (Multilink N, RelyX Ultimate and NX3-Nexus). METHODS: Upcera reinforced glass ceramics and IPS e.max CAD test specimen were processed, with different thickness, transmittance was tested by ultraviolet and visible spectrometer. The DC was evaluated using Fourier transform infrared (FT-IR) spectrometer, then the degree of conversion of polymerization before and after curing was calculated. SPSS 21.0 software package was used for data analysis. RESULTS: Transmittance decreased along with the thickness of reinforced glass ceramics increased. At 2 mm -thickness transmittance of upcera lithium disilicate glass ceramics was superior to IPS e.max CAD. The DC of dual-cured resin cement was decreased with the increase of thickness. At the same 2 mm group, the DC of Multilink N and RelyX Ultimate under upcera lithium disilicate glass ceramics were superior to that under IPS e.max CAD groups. CONCLUSIONS: At 2 mm-thickness transmittance of upcera lithium disilicate glass ceramics was superior to IPS e.max CAD. At the same 2 mm group, the DC of Multilink N and RelyX Ultimate under upcera lithium disilicate glass ceramics were superior to that under IPS e.max CAD groups.

Key words: Reinforced glass ceramics, Resin cement, Degree of conversion

中图分类号:

R783.1

朱琳琳, 仇丽鸿, 刘丽杨, 李晓琳. 加强型玻璃陶瓷厚度对树脂水门汀固化效率的影响[J]. 上海口腔医学, 2017, 26(5): 492-497.

ZHU Lin-lin, QIU Li-hong, LIU Li-yang, LI Xiao-lin. Effect of the thickness of reinforced glass ceramics on the degree of conversion of dual-cure resin cements[J]. Shanghai Journal of Stomatology, 2017, 26(5): 492-497.

参考文献

[1] 胡道勇, 钟恬. 树脂核及其于水门汀间粘结强度影响因素的研究 [J]. 中国实用口腔科杂志, 2010, 3(9): 566-568.
[2] Sundfeld Neto D, Naves LZ, Costa AR, et al. The effect of hydrofluoric acid concentration on the bond strength and morphology of the surface and interface of glass ceramics to a resin cement [J]. Oper Dent, 2015, 40(5): 470-479.
[3] BrentelAS, Ozcan M, Valandro LF, et al. Microtensile bond strength of a resin cement to feldpathic ceramic after different etching and silanization regimens in dry and aged conditions [J]. Dent Mater, 2007, 23(11): 1323-1331.
[4] Komori PC, de Paula AB, Martin AA, et al. Effect of light energy density on conversion degree and hardness of dual-cured resin cement [J]. Oper Dent, 2010, 35(1): 120-124.
[5] uncdemir AR, Yildirim C, Ozcan E, et al. The effect of a diode laser and traditional irrigants on the bond strength of self-adhesive cement [J]. J Adv Prosthodont, 2013, 5(4): 457-463.
[6] Haddad MF, Rocha EP, Assunção WG. Cementation of prosthetic restorations: from conventional cementation to dental bonding concept [J]. J Craniofac Surg, 2011, 22(3): 952-958.
[7] Larmour CJ, Bateman G, Stirrups DR. An investigation into the bonding of orthodontic attachments to porcelain [J]. Eur J Orthod, 2006, 28(1): 74-77.
[8] Ilie N, Hickel R. Correlation between ceramics translucency and polymerization efficiency through ceramics [J]. Dent Mater, 2008, 24(7): 908-914.
[9] Mohsen CA. Evaluation of push-out bond strength of surface treatments of two esthetic posts[J]. Indian J Dent Res, 2012, 23(5): 596-602.
[10] Perdigão J. Dentin bonding-variables related to the clinical situation and the substrate treatment [J]. Dent Mater, 2010, 26(2): e24-37.
[11] Waidyasekera PG, Nikaido T, Weerasinghe DD, et al. Bonding of acid-etch and self-etch adhesives to human fluorosed dentine [J]. J Dent, 2007, 35(12): 915-922.
[12] Scherrer SS, Cesar PF, Swain MV. Direct comparison of the bond strength results of the different test methods: a critical literature review [J]. Dent Mater, 2010, 26(2): e78-93.
[13] Manso AP, Silva NR, Bonfante EA, et al. Cements and adhesives for all-ceramic restorations [J]. Dent Clin North Am, 2011, 55(2): 311-332.

加强型玻璃陶瓷厚度对树脂水门汀固化效率的影响

Effect of the thickness of reinforced glass ceramics on the degree of conversion of dual-cure resin cements

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 4

编辑推荐

Metrics

本文评价

[1]	张长源, 牛刚, 靳祎祎, 于皓, 程辉. 3种树脂水门汀对人牙龈成纤维细胞的体外细胞毒性[J]. 上海口腔医学, 2017, 26(6): 594-598.
[2]	宣桂红,王海花. 酸蚀对自黏结树脂水门汀与牙本质黏结强度的影响[J]. 上海口腔医学, 2015, 24(3): 302-306.
[3]	王静, 王建鸿, 郭菁, 朱洪水. 不同浓度H2O2的桩表面处理对玻璃纤维桩与树脂水门汀黏结强度的影响[J]. 上海口腔医学, 2013, 22(5): 508-513.
[4]	许晓冬, 孟翔峰, 聂蓉蓉. 光照射模式对双重固化树脂水门汀显微硬度的影响[J]. 上海口腔医学, 2013, 22(5): 514-517.