上海口腔医学 ›› 2013, Vol. 22 ›› Issue (4): 384-388.

• 基础研究 • 上一篇    下一篇

微种植体压低基牙后双端固定桥修复基牙及支持组织的动力学研究

朱霖1,徐培成1,鲁刘磊2   

  1. (1.上海徐汇区牙病防治所,上海 200032;2.暨南大学理工学院 力学与土木工程系,广东 广州 510632)
  • 收稿日期:2013-04-19 修回日期:2013-05-22 出版日期:2013-08-10 发布日期:2013-08-10
  • 通讯作者: 徐培成,Tel:021-64226933,E-mail:xpc1238@126.com
  • 作者简介:朱霖(1976-),女,硕士,副主任医师,主要从事口腔修复临床治疗,E-mail:dentistzhulin@126.com
  • 基金资助:
    上海市卫生局科研计划课题资助项目(2009258)

Dynamic analysis of the rigid fixed bridge and related tissue after intrusion of abutment with micro screw implant

ZHU Lin1, XU Pei-cheng1, LU Liu-lei2   

  1. 1.Dental Center, Shanghai Xuhui District. Shanghai 200032; 2.Department of Mechanics and Civil Engineering, Engineering College, Jinan University. Guangzhou 510632, Guangdong Province, China
  • Received:2013-04-19 Revised:2013-05-22 Online:2013-08-10 Published:2013-08-10
  • Supported by:
    Supported by Research Fund of Science and Technology Plan Project from Bureau of Health, Shanghai Municipality (2009258).

摘要: 目的:探讨动态加载时微种植体压低基牙后固定桥力学行为的改变,为临床压低基牙后再进行牙体预备提供理论依据。方法:采用螺旋CT扫描健康人上颌骨、牙及牙周支持组织的二维图像,通过Mimics10.01、Ansys13.0等图像合成、有限元分析软件建立基牙牙槽骨水平吸收10%,上颌后牙分别压低0、0.5、1.0、1.5、2.0 mm后双端固定桥修复的三维有限元分析模型,模拟在1个咀嚼周期0.875 s内连续性施加垂直向、斜向(颊向与舌向)载荷作用,比较压低基牙前、后修复体、牙、牙周膜及硬骨板的应力随时间的变化情况。结果:随着压低量增加,修复体、牙体应力发生一定改变,这一改变与修复体结构、牙体结构有很大关系。牙周膜及硬骨板面积增大,整体应力有所降低。在一个动态载荷周期内,随着时间的积累,牙、修复体、牙周膜、硬骨板的应力均逐渐增大,在斜向载荷作用下,应力达到峰值,卸载终期仍有少量的应力残余。结论:采用微种植体压低基牙后,降低了修复体、牙、牙周膜、硬骨板的应力。在1个咀嚼周期中,基牙及支持组织的应力具有时间依赖性,侧向力对其影响大于垂直向力,且1个咀嚼周期结束时,基牙及支持组织有应力残余。随着基牙压低量的增加,残余应力减少。

关键词: 基牙, 牙周膜 , 固定桥, 动力分析

Abstract: PURPOSE: To study the variety of mechanical behavior of fixed bridge after abutments being intruded by micro screw implant and to provide theoretical principles for clinical practice of teeth preparation after intrusion of abutments under dynamic loads. METHODS: Two-dimensional images of maxilla, teeth and supporting tissues of healthy people were scanned by spiral CT and were synthesized by Mimics10.01, Ansys13.0, etc. The three-dimensional finite element mathematical model of rigid fixed bridge repairing on double end of maxillary molar was developed. Under the condition of 10% simulative abutment alveolar absorption, vertical and oblique dynamic forces were applied in a circle of mastication(0.875 s) to build mathematical model after the abutment had been intruded for 0.5, 1.0, 1.5 and 2.0 mm. Stress variety of prosthesis, teeth, periodontal ligaments and supporting tissues were compared before and after intrusion of abutments. RESULTS: Stress variety of the prosthesis occurred, which had close relationship with the structure of prosthesis and teeth, the areas of periodontal ligaments increased, stress on the whole decreased along with the increase of the length of intrusion. With time accumulating, the stress value in prosthesis, teeth, periodontal ligaments and supporting tissues increased gradually and loads in oblique direction induced peak value stress in a masticatory cycle. Some residual stress left after unloading. CONCLUSIONS: By preparing the fixed bridge after abutment intrusion by micro screw implant, the service life of abutment and fixed bridge prosthesis can be reduced. The abutment and its related tissue have time-dependent mechanical behaviors during one mastication. The influence of oblique force on stress was greater than vertical force. There is some residual stress left after one mastication period. With the increase of the intrusion on abutment, residual stress reduced.

Key words: Abutment, Periodontal ligament, Fixed bridge, Dynamic analysis

中图分类号: